stair treads forum

I am unsure on how to construct the triangular landings for my stairs.

Sweetums , Saturday, 14th of August 2010 06:59:41 PM

Do l use tread stair parts or risers and what do l use to measure the 
Sweetums
angles needed for those landings? What is the best cutting tool for stair 
Registered User
parts? Circular saw, table saw, miter saw?
 
Joined: Thursday, 10th of June 2010, 08:30:47
 
Posts: 246
 
Viewed 16334 times
 
 
Top

BABY CHEEKS , Sunday, 15th of August 2010 08:02:05 AM

You use your tread and riser material. The risers are fairly  
BABY CHEEKS
easy, just cut bevels on the ends. The treads should be cut with a jig on  
Registered User
a table saw. The angle depends on how many winders you have. The standard  
Joined: Tuesday, 18th of May 2010, 21:43:40
is 3, so the first will be cut at 30 degrees, the second at 60. Hope this  
Posts: 808
helps.  
Viewed 4213 times
 
 
 
 
 
Top

Hi All, Is it acceptable to use an alternating tread stair in a new two storey dwelling?
I am replacing the treads on my stairs, and have a wide landing at the bottom. What do I do?
Should my apartment have stair tread or stair edging
What kind of saw do I use to cut stair tread boards?
Best way to paint stairs
would like small pieces of solid woods prefer 1inch by 1 in where can I find this? please?
how can I refinish hardwood stairs
Help, Ive got Carpet Tape on my Hardwood Stairs
How do you determine the tread width and the rise of each step in a stair set with the following information?
I am getting my stairs redone.Do you stain the treads before you nail them?
tread mill versus stair stepper.. Which one
Spiral staircase with steel treads which need covering.
My house floors were built with cedar , what type of wood is best to use to replace my treads on my stairca
installing oak treads

Who is online

Users browsing this forum: 4 guests